B2 Mask Quick Start Guide

B2 Mask Quick Start Guide

Before you unbox or interact with your B2 Mask, wash your hands with soap and water. Be sure to scrub all surfaces of your hands and in between your fingers for 20 seconds. Okay, ready to go!

Insert Filters




Select a filter set, containing 2, from your filter pack.


Insert the filters, colored side out.*

*B2 Filter Lite does not have a colored side and can be loaded in either direction
Secure filters with filter caps, rotating fully.




Attach the Overlay - Original




Align the facepiece (99 logo up) with the outer fabric covering (smaller elastic strap up).

Hook the overlay centerband under the 4 angular tabs located on the outside of the facepiece.
Gently pull on the lower straps in order to secure the overlay and facepiece.





The facepiece should be positioned low on your nose and resting on the surface of your chin.

Making sure the larger straps are on the bottom, secure both ends around the back of your head. Position the elastic strap behind your head.
As you wear your B2 Mask, you may want to make adjustments to the fit for seal and comfort.


Attach the Overlay - 3D Knit



Align the 99 logo on the facepiece with the inside of the fabric overlay, removable nose clip at the top.
Insert the 4 angular tabs located on the facepiece through the openings in the overlay.


Place the lower strap (with the adjuster and loose ends) over your head with the upper strap on top.
Pull the upper strap up and onto your head.



Optimize your seal

The optimal seal can take time to find as you get use to wearing your B2 Mask.




Try placing the mask higher up on your nose bridge, and then gently pull down. With the 3D Knit, adjust the removable metal nose clip. 



You can also try to invert the seal of the facepiece near the nose for a tighter seal.





Gently adjust the length of both upper and lower straps. To tighten, hold the adjuster with one hand and pull the lose ends of the strap with the other, both in the same direction. To loosen, pull the adjuster away from the head.
Warning! Do not pull the straps to the sides in order to tighten. This may cause the adjuster to break.





Cleaning and Storage



Cleaning

Remove your filters and dispose of them before cleaning the rest of your mask. The facepiece, filter caps, and fabric overlay may be washed by hand using a mild soap or detergent. Alternatively, you can place them all in a laundry delicates bag and machine-wash on the delicates cycle with cold water, laying them flat to dry. In order to prolong the overlay life remove the metal nose clip before washing. Once everything is fully dry, replace the metal nose clip, insert new filters and reassemble your B2.

Storage

When not in use, the B2 Mask can be folded in half with the overlay straps used to secure it closed. Before storing folded, wipe down the B2 with a clean material and let it dry. Alternatively, the mask can be left on a clean surface or hung somewhere that is out of the way. Do not store in a sealed container because this prevents moisture evaporation.











    • Related Articles

    • B2 Mask Product Tutorial

      A step-by-step video to help you get the most out of your B2 Mask: In an effort to make using B2 Mask as simple as possible, we've created a short tutorial video that walks you through constructing your mask for the first time. The video covers the ...